Static bar tester

Static Bar tester

 

pictest_1.gif

HSM 1 & Multi-/Power-/Combicheck

High-voltage measurement (HSM 1)

HSM1.JPG

The high-voltage meter HSM 1 is intended to measure AC voltages of up to 10 kVAC on HAUG power packs (A).

This meter is equipped with an additional high-voltage socket for connection to an ionizing unit. Thus the power pack and ionizing unit can be tested and their voltage measured during operation (B).


HSM1_dia.gif

Technical data HSM 1

Type HSM 1 Order-No.: 12.7232.001
Measuring range 0 - 10 kVAC
Frequency 50 – 60 Hz
Measuring current max. 50 µA
Measuring voltage input via HV plug and cable
Parallel output via HV socket
Housing dimensions 143 x 66 x 62 mm

Subject to technical changes!

Performance testing of ionizing units (Multicheck)

Multi_Check.jpg

The high-voltage test unit Multicheck is a performance testing unit for HAUG ionizing units.


To test ionizing units, the test unit must be placed vertically on the ionizing pins. When the probe makes contact, the LED will illuminate green if the ionizing unit is functioning correctly (photos 1, 2, 5, 6).

Note: Please note that the Multicheck cannot measure the effective range of ionizing units.

 Multi_Check_04.jpgMulti_Check_03.jpg

Technical data Multicheck

Typ Multicheck Order-No.: 12.7229.000
Current supply 9 Volt monobloc battery
Current consumption 30 mA at LED operation
Housing dimensions 155 x 42 x 22 mm

Subject to technical changes!

Performance testing of power packs (Powercheck)

 

Power_Check.jpg

The high-voltage test unit Powercheck is a performance testing unit for HAUG power packs.

To test power packs, the black measuring probe with the spring pin must be inserted into the high-voltage socket of the power pack (photos 3, 4).

After pressing the red push button, the LED will illuminate green if the unit is functioning correctly. In case of malfunction, the LED will illuminate red.

Power_Check_07.jpgPower_Check_06.jpg 

 

COMBI Check

Combi_Check.jpg

Performance testing of power packs and ionizing units (Combicheck). The high-voltage test unit Combicheck is a performance testing unit for HAUG power packs and HAUG ionizing units.

 


A selector switch allows the units to be adjusted for the testing of power packs or ionizing units. In position “Testing of power packs”, the front LED will illuminate, while in position “Testing of ionizing units” the rear LED will illuminate. To test power packs, the black measuring probe with the spring pin must be inserted into the high-voltage socket of the power pack (photos 3, 4).

To test ionizing units, the probe must be held close to the ionizing pins (photos 1, 2).

COmbi_check_2.jpgCombi_Check_10.jpg